Removing The Toe Panel; Removing The Back Panel - KitchenAid Pro Line KHEV01RSS Technical Education

c) Unlatch and disconnect the 4-pin har-
ness connector from the temperature
sensor connector.
d) Disconnect the 4-pin sensor connec-
tor from the mounting bracket.
e) Remove the front clip from the tem-
perature sensor. To do this, hold the
clip with a pair of pliers, and twist the
sensor with your fingers while pushing
it out of the clip.
7. To remove the lint drawer switch:
a) Unlatch and disconnect the 4-pin har-
ness connector from the temperature
sensor connector. See Figure 13.
b) Remove the wires from the hook in the
blower motor housing. See Figure 14.
Figure 14. Discharge the blower capacitor at right side of
blower motor housing.
c) Pull the blower motor housing assem-
bly far enough forward so you can ac-
cess the lint drawer switch. See Fig-
ure 12.
d) IMPORTANT: Discharge the blower
capacitor by touching a 20,000 Ω re-
sistor to the terminals and chassis.
See Figure 14.
e) Remove the blower motor top housing
cover screws and position the assem-
bly out of the way.
f) Disconnect the two yellow wires from
the lint drawer switch terminals.
g) Bend the three lint drawer switch's
metal tabs straight out.
h) Release the bottom and top locking
tabs on the switch and push it out of
its housing cutout.
8. To remove the blower motor:
a) Remove the blower motor housing as-
sembly and the top housing cover by
following steps 7a through 7e.
b) Remove the four 7mm (3/8˝) nuts,
split washers, and flat washers from
the top blower motor housing. Lift the
top housing off the motor, and position
it to the left side.
c) Release and disconnect the following
connectors:
• 2 blower motor harness connectors
• 2 blower motor harness plugs from
the mounting bracket
• 3 blower capacitor wires
d) Turn the blower motor assembly over,
and position it so that you can access
the bottom screws.
e) Remove the four 7mm (3/8˝) motor
mounting plate nuts, and the five mo-
tor mounting screws from the blower
motor assembly.
f) Remove the mounting plate and pull
the motor wiring through the opening.
g) Lift the motor and fan from the housing.

REMOVING THE TOE PANEL

1. Remove four screws from the top of the
toe panel.
2. Slide the toe panel down, then pull it out
from the bottom.

REMOVING THE BACK PANEL

1. Unplug dryer or disconnect power.
2. Remove the top panel.
3. Remove the three screws from each side
of the back panel.
4. Remove three screws from around the
exhaust vent, one from the top, and one
on each side.
5. Remove the five screws that are around
the power cord access.
NOTE: There are 14 screws total for the back
panel, not including the top panel screws.
6-30