Pausing Or Restarting; Control Locked - KitchenAid Pro Line KHEV01RSS Technical Education

To Use A Manual Cycle
• Select a Manual Cycle.
• Press the plus (+) or minus (–) key until the
desired drying time is displayed. Press plus
(+) or minus (–) and the time will change by
1-minute intervals. Press and hold plus (+)
or minus (–) and the time will change by 5-
minute intervals.
NOTE: The plus (+) or minus (–) features
can be used only with Manual Cycles.
• Press TEMP until the desired temperature
illuminates.
NOTE: During a Manual Cycle, you can
change the settings for Time, Temperature,
Extra Care and Cycle End Tone signal. Press
PAUSE/CANCEL twice to stop the dryer and
clear the settings. Select another cycle or
option.
4. (OPTIONAL STEP) If desired, set the Cycle
End Tone signal. Select LOUD or SOFT to
alert you when a cycle ends.
5. Press and hold START for approximately
3 seconds until dryer starts. Be sure the
door is closed.
• If you do not press Start within 5 min-
utes of selecting the cycle, the dryer
automatically shuts off.
• If you wish to end your drying cycle after
touching Start, press PAUSE/CANCEL
twice.
STOPPING THE DRYER
To stop the dryer at any time
Press PAUSE/CANCEL twice or open the door
and press PAUSE/CANCEL once.

PAUSING OR RESTARTING

To pause the dryer at any time
Open the door or press PAUSE/CANCEL
once.
To restart the dryer
Close the door. Press and hold START until
dryer starts.
NOTE: Drying will continue from where the
cycle was interrupted if you close the door
and press Start within 5 minutes. If the cycle is
interrupted for more than 5 minutes, the dryer
will shut off. Select new cycle settings before
restarting the dryer.

CONTROL LOCKED

This feature allows you to lock your settings to
prevent unintended use of the dryer. You can
also use the Control Locked feature to avoid
unintended cycle or option changes during dryer
operation.
To enable the Control Locked feature when
dryer is running:
Press and hold the DRY RACK button for 3
seconds. The control is locked when a single
beep is heard and the Control Locked icon is
displayed in the status window. The icon is
located next to the Dry Rack button and will
illuminate when control locked.
• When the dryer is off, it is not necessary
to turn the control on before activating the
Control Locked feature.
To unlock:
Press and hold the DRY RACK button for 3
seconds to turn this feature off.
NOTE: When the dryer is running and Control
Locked is on, the dryer can be stopped by press-
ing the PAUSE/CANCEL button, but cannot be
restarted until the control is unlocked.
3-2