KitchenAid Pro Line KHEV01RSS Technical Education page 57

Front-loading gas and electric dryers
Hide thumbs Also See for Pro Line KHEV01RSS:
Table of Contents

Advertisement

9.
Remove the four T-20 screws from the
exhaust vent bracket and pull the bracket
off the vent.
2 Screws
Exhaust Vent Bracket
2 Screws
10. Remove the two T-20 screws from the front
of the blower.
11. Remove the four 7/16˝ nuts from the blower
bracket, push the bracket back so it clears
the two chassis studs, and remove it from
under the blower.
2 Screws
Blower
Blower Bracket Nuts
12. Disconnect the two red-silver wires from
the high limit thermostat terminals.
13. Unlatch and disconnect the temperature
sensor connectors from the mounting
bracket.
Temperature Sensor
Connectors
14. Unlatch and disconnect the blower motor
and capacitor connectors and the wiring
harness connectors from the mounting
bracket.
15. Unhook and pull the wires out of the two
wire retainers.
Wire
Capacitor Connectors
Retainer
4-17
High Limit Thermostat
Red-Silver Wires
Wiring Harness
Connectors
Blower Motor &
Wire Retainer

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro line khgv01rss

Table of Contents