Removing The High Limit Thermostat, Thermal Cutoff (Tco), And Heater Elements (Electric Dryers Only) - KitchenAid Pro Line KHEV01RSS Technical Education

REMOVING THE HIGH LIMIT THERMOSTAT,
THERMAL CUTOFF (TCO), AND HEATER ELEMENTS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Pull the dryer out from the wall.
3. Remove the toe panel from the front of the
dryer (see page 4-6 for the procedure).
4. IMPORTANT: Discharge the blower ca-
pacitor by touching a 20,000 Ω resistor
to the terminals and chassis ground (see
page 4-14).
(ELECTRIC DRYERS ONLY)
Heater Assembly
5. Remove the two T-20 screws from the
heater bracket.
6. Remove the two 7/16˝ hex nuts from the
heater bracket.
7. Remove the heater bracket from the two
studs, rotate it to the right side, and prop
the heater up with the bracket so that you
can access the two nuts at the rear of the
heater.
Heater
Assembly
8. Remove the two 11/32˝ nuts from the rear
of the heater housing.
4-8
Screws
Hex Nuts
Bracket
Rear Nuts