Removing The Belt And Drum - KitchenAid Pro Line KHEV01RSS Technical Education

REMOVING THE BELT AND DRUM

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the top cover from the dryer (see
page 4-2 for the procedure).
4. Pull the lint filter out of the toe panel as
far as it will go, press down on the release
lever, and remove the filter.
Release Lever
Lint Filter
5. Open the dryer door.
6. Remove the four T-20 screws from the top
of the toe panel, (see the top right photo),
then remove the panel by pulling the top
forward, and lifting and unhooking the bot-
tom from the slots.
7.
8.
9.
10 Rear Panel Screws
Toe Panel
4-19
4 Screws
Toe Panel
Remove the heater assembly from the
front of the dryer (see page 4-8 (electric)
or 4-10 (gas) for the procedure).
Remove the three T-20 screws from the
AC terminal wiring cover (electric models
only) and remove the cover.
Remove the ten T-20 screws from the
rear panel, and remove the panel from the
dryer.
AC Terminal Wiring Cover
Rear Panel
Screws