Adjusting A Drum Roller - KitchenAid Pro Line KHEV01RSS Technical Education

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the belt and drum from the dryer
(see pages 4-19 through 4-21 for the pro-
cedure).
NOTE: The front and rear rollers are adjusted
in the same manner. However, the front roller
brackets are held in place with studs, while
the rear panel roller brackets are held in place
with bolts. The rear rollers are shown in this
procedure.
Perform step 4 only if you have an electric dryer;
otherwise, proceed to step 5.
4. Rear Rollers Only: Remove the AC ter-
minal box (electrical models only) from
the rear panel as follows (see the top right
photo):
a) Remove the two T-20 cross brace screws
from inside the AC terminal box.
b) Remove the screws for the three power
cord leads and remove the leads from
the terminal block. IMPORTANT: Make
sure that you orient the three power cord
leads correctly when you reconnect
them to the terminal block screws (as
shown in the photo).
• The marked lead connects to the
black wire terminal.

ADJUSTING A DRUM ROLLER

The center lead connects to the white
•
wire terminal.
• The unmarked lead connects to the
red wire terminal.
c) Remove the screw from the ground
wire.
d) Remove the two T-20 screws from the
AC terminal block, then pull the block
and the rubber grommet through the
panel slot.
Cross Brace Screws
Screw
(1 of 2)
Marked-Center-Unmarked
(Power Cord Lead Orientation)
5. Loosen the three 7/16˝ bolts and washers
from the roller bracket. NOTE: To adjust the
left roller (facing the rear of the panel), you
will have to remove the air duct to access
two of the bolts.
Continued on the next page.
4-23
Blk Wht Red
AC Terminal Box
Air Duct
Left & Right
Roller Bracket
Hardware
Ground
Wire