KitchenAid Pro Line KHEV01RSS Technical Education page 43

9. To remove the user interface:
a) Using a pair of long-nose pliers, squeeze
the locking tabs on the wire tie standoff,
and pull the standoff out of the control
panel bracket mounting hole.
b) Press and release the locking arm, and
disconnect door switch connector J6
from the control board.
c) Press down on the locking arm, (see the
round inset), and pull the user interface
connector off the user interface board.
Door Switch J6
Wire Tie Standoff
User Interface
Connector
d) Position the control panel facedown
on a protected surface.
e) Remove the screws and six hold-down
brackets, and lift the user interface
board assembly from the panel.
Hold-Down Screws
Locking Arm
4-3
10. To remove the control board:
a) Loosen (do not remove) the four T-20
screws from the control board cover,
slide the cover to the right, and re-
move it from the dryer.
4 Control Board
Cover Screws
b) Remove the three Phillips screws from
the control board, unsnap the board
from the mounting posts, and remove it.
c) Press the new control board onto the
mounting posts, and secure it with the
three Phillips screws you removed in
the previous step.
d) Transfer each of the wire connectors
from the old control board to the new
one. Make sure that the connectors
are securely fastened.
J2
3 Control Board Screws
White Wires
Relay K6
Continued on the next page.
J1
Black Wires
Relay K4
J3