KitchenAid Pro Line KHEV01RSS Technical Education page 67

9. Gas Models: Disconnect the following con-
nectors from the burner assembly:
a) Flame Sensor (WH & BU wires)
b) Thermal Cutoff (TCO) (2 BLK)
c) High Limit Thermostat. (2 WH)
Flame Sensor
2 Black
Blue & White
10. Route all of the loose wiring toward the
front panel of the dryer.
11. Open the dryer door and remove the six
screws from the two door hinges (3 each).
12. Remove the six T-20 screws from the front
panel (4 on top, 2 at the bottom).
Top Front Panel Screws
Front Panel
High Limit
TCO
Thermostat
2 White
Bottom Left
Panel Screw
13. Lift the front panel straight up so the round
pins are out of their keyhole slots in the
chassis, pull the panel forward, and remove
it from the dryer.
14. Remove the three T-20 screws from the
bottom of the side panel.
4-27
Lift Staight Up
3 Side Panel Screws
Continued on the next page.