KitchenAid Pro Line KHEV01RSS Technical Education page 10

Parts needed
Check local codes and with gas supplier.
Check existing gas supply, electrical supply
and venting. Read "Electrical Requirements,"
pages 2-5 & 2-13, "Gas Supply Require-
ments," page 2-13, and "Venting Require-
ments," page 2-15 before purchasing parts.
• For close-clearance installations between
33˝ (83.8 cm) and 38˝ (96.5 cm), see
"Plan Vent System," page 2-17 for venting
requirements.
Mobile home installations require metal ex-
haust system hardware available for purchase
from the dealer from whom you purchased
the dryer. For further information, please refer
to the "Assistance or Service" section of the
"Use & Care Guide."
• Mobile Home Installation Kit. Ask for Part
Number 346764.
• Metal exhaust system hardware.
38"
(96.5 cm)
OPTIONS
Pedestal
Are you placing the dryer on a pedestal?
You may purchase a pedestal separately for
this dryer. This pedestal will add about 11˝
(27.9 cm) to the height of your dryer for a total
height of approximately 53˝ (134.6 cm).
For a garage installation, you will need to place
the pedestal at least 7˝ (17.8 cm) above the
floor.
To order, call the dealer from whom you pur-
chased your dryer or refer to the "Assistance
or Service" section of the "Use & Care Guide."
Ask for Part Number LAV2701RSS.
Door Reversal Kit
Would you like to change your dryer door
swing from a right-side opening to a left-side
opening? To do so, you will need to purchase
a Door Reversal Kit.
To order, call the dealer from whom you pur-
chased your dryer or refer to the "Assistance
or Service" section of the "Use & Care Guide."
Ask for Part Number 8182652.
2-2
Optional pedestal