Hood Sensor
Description
Hood sensor
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the optical drive
4.
Unplug the hood sensor cable from the white system board connector labeled HSENSE (1) and
remove the cable from the white clip mounted on the inside chassis wall.
5.
Slide the hood sensor into the chassis to remove it from its slot (2). Disengaging the hood
sensor from the chassis may require use of a screwdriver or similar tool.
Figure 9-28
To install the hood sensor, reverse the removal procedures.
(Removing the Optical Drive on page
Removing the hood sensor
(Preparation for Disassembly on page
(Access Panel on page
Spare part number
638816-001
206).
207).
216).
Hood Sensor 233