HP 8200 Elite Series Maintenance And Service Manual page 98

7. If you are not installing a new expansion card, install an expansion slot cover to close the open
slot.
CAUTION:
expansion slot cover for proper cooling of internal components during operation.
8. To install a new expansion card, slide the bracket on the end of the card down into the slot on
the back of the chassis and press the card down firmly into the socket on the system board.
Figure 6-12
NOTE:
connector seats properly in the expansion card slot.
9. Close the expansion card retention latch, making sure that it snaps firmly into place.
10. Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
11. Replace the computer access panel.
12. Reconnect the power cord and turn on the computer.
13. Lock any security devices that were disengaged when the computer access panel was removed.
14. Reconfigure the computer, if necessary.
86 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis
After removing an expansion card, you must replace it with a new card or
Installing an Expansion Card
When installing an expansion card, press firmly on the card so that the whole