HP 8200 Elite Series Maintenance And Service Manual page 297

Table D-10 Solving Mouse Problems (continued)
Mouse does not respond to movement or is too slow.
Cause
Program in use has stopped responding to commands.
Mouse may need cleaning.
Mouse may need repair.
Computer is in standby mode.
Mouse will only move vertically, horizontally, or movement is jerky.
Cause
Mouse roller ball or the rotating encoder shafts that make
contact with the ball are dirty.
Solution
Shut down the computer using the keyboard then restart the
computer.
Remove the roller ball cover on the mouse and clean the
internal components.
See the Worldwide Limited Warranty for terms and
conditions.
Press the power button to resume from standby mode.
CAUTION: When attempting to resume from standby
mode, do not hold down the power button for more than four
seconds. Otherwise, the computer will shut down and you
will lose any unsaved data.
Solution
Remove roller ball cover from the bottom of the mouse and
clean the internal components with a mouse cleaning kit
available from most computer stores.
Solving Keyboard and Mouse Problems 285