Optical Drive Rail - HP 8200 Elite Series Maintenance And Service Manual

Optical Drive Rail

Description
Optical drive rail and cable kit
The optical drive rail sits behind the USB ports on the front of the chassis.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the optical drive
4. Remove the hard drive
5. Remove the two Torx screws that secure the rail to the chassis (1), lift the tab (2) on the rail,
slide the rail toward the rear of the unit (3), and then pull the rail up and out of the chassis.
Figure 9-19
To install the optical drive rail, reverse the removal procedures.
(Removing the Optical Drive on page
(Hard Drive on page
Removing the optical drive rail
(Preparation for Disassembly on page
(Access Panel on page
219).
Spare part number
594219-001
206).
207).
216).
Optical Drive Rail 223