HP 8200 Elite Series Maintenance And Service Manual page 158

●
If you are installing a 2.5-inch hard drive:
◦
◦
146 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis
Install four 6-32 silver and blue isolation mounting guide screws in the adapter bracket
(two on each side of the bracket).
Figure 7-22 Installing Isolation Mounting Guide Screws in the 2.5-inch Adapter
Bracket
Install the drive into the slot on the adapter bracket with the PCA side facing down,
aligning the three tabs on the bracket with the drive. Ensure that the power and data
connectors on the drive are properly oriented.
Figure 7-23 Installing the Drive in the Adapter Bracket