Heat Sink - HP 8200 Elite Series Maintenance And Service Manual

Heat sink

Description
Heat sink
The heat sink is secured atop the processor with four captive Torx screws. The heat sink does not
include a fan.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the fan duct
4. Remove the front fan
5. In the order shown, loosen the four captive screws that secure the heat sink to the system board
tray.
CAUTION:
an X) to even the downward forces on the processor. This is especially important as the pins on
the socket are very fragile and any damage to them may require replacing the system board.
Figure 8-34
196 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
(Access Panel on page
(Fan duct on page
(Front Fan Assembly on page
Heat sink retaining screws should be removed in diagonally opposite pairs (as in
Loosening the heat sink screws
(Preparation for Disassembly on page
166).
189).
190).
Spare part number
645326-001
165).