Installing A 5.25-Inch Or 3.5-Inch Drive Into A Drive Bay - HP 8200 Elite Series Maintenance And Service Manual

5. A latch drive bracket with release tabs secures the drives in the drive bay. Lift the release tab on
the latch drive bracket (1) for the drive you want to remove, then slide the drive from its drive bay
(2).
Figure 7-16

Installing a 5.25-inch or 3.5-inch Drive into a Drive Bay

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. If you are installing a drive in a bay covered by a bezel blank, remove the bezel blank. See
Blanks on page 128
142 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis
Removing the Drives
(Computer Access Panel on page
(Front Bezel on page
for more information.
(Preparation for Disassembly on page
126)
127)
125)
Bezel