Hood Sensor - HP ProOne 600 G4 Maintenance & Service Manual

Hood sensor

The hood sensor is located to the right of the system board.
To remove the hood sensor:
1. Prepare the computer for disassembly (see
2. Remove the stand (see
3. Remove the rear port cover (see
4. Disconnect the hood sensor cable from the system board (1).
5. Remove the cable from the clips in the computer (2).
6. Pry the sensor out of the slot to remove it (3).
To install the hood sensor, reverse the removal procedures.
Preparing to disassemble the computer on page
Stand on page 19).
Rear port cover on page 24).
19).
Hood sensor 35