HP 8200 Elite Series Maintenance And Service Manual page 226

5. Slide the new SODIMM into the socket at approximately a 30° angle (1) then press the SODIMM
down (2) so that the latches lock it in place.
Figure 9-7
NOTE:
with the tab on the memory socket.
6. Replace the access panel.
7. If the computer was on a stand, replace the stand.
8. Reconnect the power cord and turn on the computer.
9. Lock any security devices that were disengaged when the computer cover or access panel was
removed.
The computer automatically recognizes the additional memory when you turn on the computer.
214 Chapter 9 Removal and Replacement Procedures – Ultra-Slim Desktop (USDT) Chassis
Installing a SODIMM
A memory module can be installed in only one way. Match the notch on the module