◦
Hold the drive and bracket firmly together and turn the assembly over. Install four M3
screws to secure the drive to the bracket.
Figure 7-24
4.
Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until
the drive snaps into place. The bottom bay is for the primary hard drive. The upper bay is for an
optional secondary hard drive.
Figure 7-25
Sliding a Hard Drive into the Drive Bay
5.
Connect the power cable and data cable to the back of the hard drive.
NOTE:
The power cable for the hard drives is a two-headed cable that is routed from the
system board to the rear of the hard drive bays.
Securing the Drive in the Adapter Bracket
Drives 147