Power Supply - HP 8200 Elite Series Maintenance And Service Manual

Power Supply

Description
Power supply, 320W, 90% efficient
Power supply, 320W
WARNING!
replacement power supply provided by HP, or a power supply purchased as an accessory from HP
should be used with the computer.
The power supply is secured to the rear of the chassis by four Torx screws. A lever on the chassis
floor also holds the power supply in place.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Disconnect all power cables from the system board as follows:
●
white 4-pin PWRCPU
●
white 4-pin PWR
●
white 6-pin PWRCMD
4. Remove the power cables from the white plastic clamp on the chassis floor.
5. Remove the four Torx screws (1) that secure the power supply to the chassis.
6. Press the tab (2) in front of the power supply, slide the power supply toward the front of the
computer, and then lift the power supply out of the chassis (3).
Figure 6-48
To reduce potential safety issues, only the power supply provided with the computer, a
Removing the power supply
(Preparation for Disassembly on page
(Computer Access Panel on page
Spare part number
613764-001
613765-001
73).
74).
Power Supply 117