Bezel Blanks; Memory; Dimms - HP 8200 Elite Series Maintenance And Service Manual

Bezel Blanks

On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch external drive bays that
need to be removed before installing a drive. To remove a bezel blank:
1. Remove the access panel
2. Remove the front bezel
3. To remove a bezel blank, push the two retaining tabs that hold the bezel blank in place towards
the outer right edge of the bezel (1) and slide the bezel blank back and to the right to remove it
(2).
Figure 8-3
4. Replace the front bezel.

Memory

Description
4-GB, PC3-10600
2-GB, PC3-10600
1-GB, PC3-10600
The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3-
SDRAM) dual inline memory modules (DIMMs).

DIMMs

The memory sockets on the system board can be populated with up to four industry-standard DIMMs.
These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum
memory support, you can populate the system board with up to 16-GB of memory configured in a
high-performing dual channel mode.
168 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
(Access Panel on page
(Front Bezel on page
Removing a bezel blank
166).
167)..
Spare part number
585157-001
635803-001
635802-001