Hood sensor
The hood sensor is attached to the rear of the chassis.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the drive cage
4.
Disconnect the hood sensor cable from the system board connector labeled HSENSE (1).
5.
Slide the hood sensor out of the slot on the rear of the chassis (2). A tool such as a screwdriver may be
required to disengage the hood sensor from the slot.
To install the hood sensor, reverse the removal procedure.
(Preparation for disassembly on page
(Access panel on page
(Drive cage on page
22).
18).
17).
Hood sensor
47