Removing The Pci Tray In An Rm7000Class Workstation; Figure 2-36 Releasing The Pci Tray - Silicon Graphics O2+ Hardware Reference Manual

Removing the PCI Tray in an RM7000class Workstation

007-4486-001
9. Remove the wrist strap.
10. Reinstall the PCI tray as follows:
• If you have an RM7000class workstation, see "Reinstalling the PCI Tray in an
RM7000class Workstation."
• If you have an R12000class workstation, see "Reinstalling the PCI Tray in an
R12000class Workstation."
To remove the PCI tray in an RM7000class workstation, follow these steps:
1. Push up the lever on the side of the PCI tray to release it (Figure 2-36). The tray pops
up.
Figure 2-36 Releasing the PCI Tray
2. Push down slightly on the rear of the PCI tray and remove it from the system
module (Figure 2-37). Do not remove the PCI board from the tray, if one is installed.
Installing an Option Board
57