Installing A Pci Board In An Rm7000Class Workstation; Figure 2-13 Releasing The Pci Tray - Silicon Graphics O2+ Hardware Reference Manual

Chapter 2: Installing or Removing Memory and Option Boards

Installing a PCI Board in an RM7000class Workstation

38
To install a PCI board in an RM7000class workstation, follow these steps:
Note: Check the documentation and software release notes that come with the PCI board
for instructions on installing the software. The software may include online software
guides.
1. If you have not already done so, remove the power cable, and remove the system
module from the chassis. (See "Removing the System Module.")
Caution: The small, printed circuit board beneath the PCI tray contains a host chip
!
with important system information such as the serial number. Do not mix PCI trays
between workstations. If you remove the PCI tray, always replace it, or the
workstation will not operate correctly.
2. Release the PCI tray by pushing up the lever on the side (Figure 2-13). The tray pops
up.
Figure 2-13 Releasing the PCI Tray
3. Push down slightly on the rear of the PCI tray and remove it from the system
module (Figure 2-14).
007-4486-001