Removing Memory Modules; Figure 2-10 Checking The Dimm Installation - Silicon Graphics O2+ Hardware Reference Manual

Chapter 2: Installing or Removing Memory and Option Boards

Removing Memory Modules

36
• The DIMMs should all be absolutely vertical (no leaning).
• The latches on the sides should fit snugly against each DIMM.
Figure 2-10 Checking the DIMM Installation
7. Remove the wrist strap and follow the steps in "Reinstalling the System Module."
To remove memory modules, follow these steps:
1. If you have not already done so, remove the power cable, and remove the system
module from the chassis. See "Removing the System Module."
2. Before touching any of the components, ground yourself to a metal part of the
chassis, as follows:
• Unwrap the first two folds of the wrist strap and wrap the exposed adhesive
side firmly around your wrist.
• Unroll the rest of the strap and peel the liner from the copper foil at the opposite
end.
• Attach the copper foil to the PCI tray. Attach the wrist strap to your wrist and to
the PCI tray (Figure 2-11).
007-4486-001