Figure 2-30 Attaching The Wrist Strap - Silicon Graphics O2+ Hardware Reference Manual

007-4486-001
• Peel the liner from the copper foil at the opposite end.
• Attach the copper foil to the metal part of the chassis.
Figure 2-30 Attaching the Wrist Strap
4. If there is a filler panel covering the I/O slot, remove the filler panel as follows:
• Use a Phillips screwdriver to remove the two screws that hold it (Figure 2-31).
• Push the filler panel inward.
• Remove the filler panel and save it. In the event that you remove the option
board and do not replace it, you must reinstall the panel.
Installing an Option Board
53