Reinstalling The Pci Tray In An R12000Class Workstation; Figure 2-43 Pci Tray Seated Correctly - Silicon Graphics O2+ Hardware Reference Manual

Reinstalling the PCI Tray in an R12000class Workstation

007-4486-001
Figure 2-43 PCI Tray Seated Correctly
4. Follow the steps in "Reinstalling the System Module."
To reinstall the PCI tray in an R12000class workstation, follow these steps:
1. Replace the PCI tray in the system module, as follows:
• Lower the PCI tray, engaging it on the tab on the side of the system module
(Figure 2-44).
• Insert the PCI connector beneath the tray into the slot on the system module.
• Once the connector is aligned, push down firmly until it is completely seated.
Note: If the PCI tray is not completely seated, the system module will not slide back
into the chassis.
Installing an Option Board
63