Structural Concepts GP641RRLB Installation And Operating Manual page 35

CLEANING SCHEDULE - TO BE PERFORMED BY STORE PERSONNEL, CONTINUED
AREA FREQ.
Case Daily Sneeze Guard Glass/Supports/Glass Sliding Doors: After removing pans, clean with a
Exterior household or commercial glass cleaner and a soft cloth or paper towel. Wipe off all residue.
Daily Acrylic: Acrylic sneeze guard must be cleaned with a mild soap and water solution and a soft
cloth. Caution! Never use ammonia-based cleaners on acrylic. Incorrect cleaning agents
or abrasive cleaning cloths cause surface to 'cloud' over time.
Daily Heated Stone Surface: See next page.
Daily End Panels, Front Panel, Toe-Kick, Rear Sliding Doors (Model GP841R.5184), Storage
Area, etc.: Wipe down with warm water and mild soap solution and non-abrasive cloth.
Daily Stainless Steel Surfaces:
See CLEANING SCHEDULE - TO BE COMPLETED BY STORE PERSONNEL, CONT'D:
STAINLESS STEEL section in this manual for cleaning specifics.
Case Daily Storage Areas, Glove Box Holder, Sanalite Wrapping/Cutting Board: Wipe out with warm
Interior water and mild anti-bacterial soap solution and non-abrasive cloth. See illustration below.
Rear Door Compartment: Open rear compartment door. Wipe out area with warm water, mild
Daily
soap solution and non-abrasive cloth. DO NOT to touch or dislodge cooler drain hose.
Daily Risers: Wipe down with warm water and mild anti-bacterial soap solution & non-abrasive cloth.
For more extensive cleaning (stubborn stain removal), remove from case, submerse in warm,
soapy water and use non-abrasive cloth. Note: See PREVENTIVE MAINTENANCE (TO BE
PERFORMED BY TRAINED SERVICE PROVIDER) section in manual for sample view of risers.
Sneeze Guard
Support
End Panel
(Typical)
Storage Area
Glove Box Holder
Sneeze Guard
Glass
Refrigerated
Rear Drawers
INSTRUCTIONS
Sneeze Guard
Sneeze Guard
Support
Refrigerated Rear
Door Compartment
35
Sanalite Wrapping /
Cutting Board (Typical)
Glass
Refrigerated
Storage Area
Rear Drawers