Vacuum Pump Removal And Inspection; Governor Removal And Inspection - Rotax 912 Series Maintenance Manual

3.2)

Vacuum pump removal and inspection

See Fig. 72-4.
■
CAUTION : Observe the vacuum pump manufacturers specifications for
Unscrew the 4 hex. nuts (1) M6 and remove the lock washers. Remove the
vacuum pump (2) from the crankcase (4) together with the gasket and the
retaining flange (3).
3.3)

Governor removal and inspection

See Fig. 72-34 in 72-00-00.
■
CAUTION : Observe the governor manufacturers specifications for mainte-
Unscrew the 3 allen screws (16) M8x40 and the 1 allen screw (17) M8x35 and
remove together with the lock washers. Remove the governor with the gasket.
◆ NOTE:
Effectivity 912/914 Series
Edition 1 / Rev. 0
BRP-Rotax
Maintenance Manual
maintenance, inspection and repairs!
4
3
00251
nance and repairs!
The screwing can be different depending on the type of gover-
nor. See SB-912-052 and/or SB-914-035, " Installation / Use of
governor", latest issue.
1
Fig. 72-4
2
72-00-00
page 10
May 01/2007