Table of Contents
Advertisement
AAM1212 User's Guide
Figure 69 DHCP Relay
The following table describes the labels in this screen.
Table 40 DHCP Relay
LABEL
Enable DHCP
relay
Remote DHCP
server IP
Enable Option 82
Option82
Apply
Cancel
140
DESCRIPTION
Enable DHCP relay to have the AAM relay client TCP/IP configuration requests to
a DHCP server and the server's responses back to the clients.
Enter the IP address of the DHCP server to which the AAM should relay DHCP
client TCP/IP configuration requests.
Select the Enable Option 82 check box to have the AAM add information (slot
number, port number and VLAN ID) to client TCP/IP configuration requests that it
relays to a DHCP server.
Use this field to specify up to 23 ASCII characters of additional information for the
AAM to add to the DHCP client TCP/IP configuration requests that it relays to a
DHCP server.
Examples of information you could add would be the chassis number or the device
identifier of the AAM.
Click Apply to save your changes to the AAM's volatile memory. The AAM loses
these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 17 DHCP Relay
Advertisement
Table of Contents
Troubleshooting
