1 Right-click the Backup Text Configuration Click here link and click Save Target As.
Or:
Click the Backup Text Configuration Click Here link and then click Save.
2 In the Save As screen, choose a location to save the file on your computer from the Save
in drop-down list box and type a descriptive name for it in the File name list box. Click
Save to save the configuration file to your computer.
Note: See the chapters on commands to edit the configuration text file.
You can change the ".dat" file to a ".txt" file and still upload it to the AAM.
21.5 Load Factory Defaults
From the Maintenance screen, use Restore Default Configuration to clear all AAM
configuration information you configured and return to the factory defaults. Click OK in the
following screen.
Figure 83 Confirm Restore Factory Default Settings
Click OK to begin resetting all AAM configurations to the factory defaults and then wait for
the AAM to restart. This takes up to two minutes. If you want to access the AAM web
configurator again, you may need to change the IP address of your computer to be in the same
subnet as that of the default AAM IP address (192.168.1.1).
Figure 84 Restart After Load Factory Defaults
21.6 Reboot System
From the Maintenance screen, use Reboot System to restart the AAM without physically
turning the power off. Press the Click Here button next to Reboot System to display the
following screen.
Chapter 21 Maintenance
AAM1212 User's Guide
155