Vlan Enable; Vlan Disable; Vlan Show Command; Figure 142 Vlan Delete Command Example - ZyXEL Communications AAM1212 User Manual

AAM1212 User's Guide
where
<vlanlist>
This command deletes the specified VLAN ID entry from the static VLAN table
The following example deletes entry 2 in the static VLAN table.

Figure 142 VLAN Delete Command Example

ras> switch vlan delete 2

28.9 VLAN Enable

Syntax:
switch vlan <vid>
This command enables the specified VLAN ID in the SVLAN (Static VLAN) table.

28.10 VLAN Disable

Syntax:
switch vlan disable <vid>
This command disables the specified VLAN ID in the SVLAN (Static VLAN) table. You
cannot disable a VLAN if any PVIDs are set to use the VLAN or the VLAN is the CPU
(management) VLAN.

28.10.1 VLAN Show Command

Syntax:
switch vlan show <vlanlist>
where
<vlanlist>
234
= You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs:
<1,5,6~10>.
You cannot delete a VLAN if any PVIDs are set to use the
VLAN or the VLAN is the CPU (management) VLAN.
= You can specify a single VID: <1>, all VIDs: <*>, a list of
VIDs: <1,3>, you can also include a range of VIDs:
<1,5,6~10>.
Chapter 28 Switch Commands