Monitor Tlimit Command; Figure 107 Monitor Vlimit Command Example - ZyXEL Communications AAM1212 User Manual

where
<idx>
<high>
<low>
This command sets the maximum and minimum voltage at a voltage sensor.
The following example sets the highest (1.242) and the lowest (1.035) voltage limit at the first
sensor.

Figure 107 Monitor Vlimit Command Example

ras> sys monitor vlimit 1 1.242 1.035

26.2.22 Monitor Tlimit Command

Syntax:
ras> sys monitor tlimit <idx> <high> <low>
where
<idx>
<high>
<low>
The following example sets the highest (97.0) and the lowest (-55.0) temperature limit at the
first sensor.
Chapter 26 Sys Commands
= The index number of the sensor that can detect and report the
voltage.
= The maximum voltage limit at a sensor.
You can specify a voltage with up to three digits after a decimal
point (0.941 for example).
= The minimum voltage limit at a sensor.
You can specify a voltage with up to three digits after a decimal
point (0.941 for example).
= The index number of the temperature sensor that can detect and
report the temperature.
= The maximum temperature limit at a sensor.
You can specify a temperature with up to three digits after a
decimal point (-50.025 for example).
= The minimum voltage limit at a sensor.
You can specify a temperature with up to three digits after a
decimal point (-50.025 for example).
AAM1212 User's Guide
193