Shutting Down The Focus; Powering Off The Focus; Removing The Battery From The Focus - Faro FOCUS3D X 130 User Manual

®
FARO Laser Scanner Focus
January 2014
the inclinometer screen. For more information, see "Inclinometer (Dual Axis
Compensator)" on page 96.

Shutting Down the Focus

To shut down the Focus
shutdown button in the controller software under Home > Manage. All LEDs
will start blinking blue. As soon as the Focus
process the LEDs will stop blinking and you can safely remove the battery and
the power supply.
DO NOT turn off the power of the Focus
complete. The Focus
PC must be shut down before turning off the power supply. If the power supply is
disconnected or switched off without the Focus
down, it may damage the internal PC and might lead to a loss of data. Pressing
and holding the button more than 10 seconds will switch the Focus
without shutting down. Please use this option only if the Focus
shut down regularly because of a malfunction.
: If the Focus
N
OTE
process could take more time as usual as the Focus
hard disk for errors. Some settings, which were made shortly before shutting
down the Focus

Powering Off the Focus

Once the Focus
power cable first, then disconnect the power supply cable from the Focus
130, remove the battery and secure the equipment in protective cases.

Removing the Battery from the Focus

1 Open the battery cover.
2 Push the fastener to release the battery.
3 Remove the battery.
4 Close the battery cover.
Chapter 5: Getting Started
3D
X 130 Manual
3D
X 130, shortly press its On/Off button or use the
3D
X 130 has a PC with a hard drive integrated. This internal
3D
X 130 had not been shut down properly, the next boot
3D
X 130, might also be lost.
3D
X 130 has been completely shut down, disconnect the AC
X 130
3D
3D
X 130 has finished the shutdown
3D
X 130 before the shut down cycle is
3D
X 130 being previously shut
3D
X 130
3D
3D
58
3D
X 130 off
3D
X 130 does not
X 130 might check its
X 130
3D
X