Switching The Focus 3D X 130 On - Faro FOCUS3D X 130 User Manual

forcibly insert the plug in a wrong direction, the plug, the scanner's power
socket as well as the scanner can be damaged.
3 Connect the AC power cable to the power supply as well as to a power outlet.
Check the input voltage on the type label before connecting. The upper LEDs
of the scanner on the mirror and sensor side as well as the LED of the scanner
mount begin to illuminate blue.
: To avoid electrical shock, outdoor use of the power supply unit is not
N
OTE
permitted. Use the power supply unit in dry indoor environments only.
Switching the Focus
Pressing the scanner's On/Off button will start the boot process, which will be
indicated by the scanner LEDs blinking blue. If power is supplied by the battery
only and its charge state is too low to start the scanner, the scanner LEDs will
blink orange.
Figure 5-7 Power Supply Connected to Focus 3D X 130
3D
®
FARO Laser Scanner Focus
X 130 On
35
3D
X 130 Manual
January 2014
[
Chapter 5: Getting Started