Chapter 5: Getting Started; Charging The Faro Powerblock Battery; Charging The Battery In The Focus - Faro FOCUS3D X 130 User Manual

Chapter 5: Getting Started

This chapter will provide preliminary steps and basic Focus
and will guide you step-by-step from setting up the Focus
your first scan.

Charging the FARO PowerBlock Battery

The FARO PowerBlock battery can be charged in the Focus
FARO PowerDock battery charger. Carefully read the safety measures described
in "PowerBlock Battery Safety Measures" on page 11 and "PowerDock Battery
Charger Safety Measures" on page 12 before using them.
It is recommended to fully charge the battery before use and that a spare battery
is kept on hand just in case it is needed during your scan project.

Charging the Battery in the Focus

3D
The Focus X 130 doesn't need to be switched on in order to charge the battery.
1 Mount the battery into the Focus
Battery" on page 33.
2 Connect the AC Adaptor to the Focus
"Supplying Power with the External Power Supply Unit" on page 34.
3D
3 If the Focus
as well as the LEDs at the scanner mount will start blinking slowly blue while
charging. The LEDs will stop blinking and will illuminate constantly blue
when the battery is fully charged.
3D
4 If the Focus
battery in the scanner's user interface under Home > Manage > General
Settings > Power Management. For more information, see "Power
Management" on page 81.
:
P
LEASE NOTE
• Take out the Focus
power supply to the scanner.
• Use the power supply unit indoor only.
• Before longer storage, remove the power supply unit and the battery from the
3D
Focus X 130.
X 130 is turned off, the upper LEDs on both sides of the scanner
X 130 is turned on, you can check the exact charge state of the
3D
X 130 from the transport case before connecting the
®
FARO Laser Scanner Focus
3D
3D
X 130. See "Supplying Power with the
3D
X 130 and the wall outlet. See
27
3D
3D
X 130 operations
3D
X 130 to recording
3D
X 130 or in the
X 130
Chapter 5: Getting Started
X 130 Manual
January 2014