Mechanical Security - Faro FOCUS3D X 130 User Manual

In accordance with IEC 60825-1:2007, the Focus
following explanatory label:

Mechanical Security

• WARNING: The mirror unit rotates with high speed while scanning and for a
short period after the scan. While the mirror is rotating keep distance to the
product and do not touch the rotating mirror unit with your hands, fingers or
any objects at the risk of personal injury and damage to the Focus
3D
• The Focus X 130 will rotate clockwise up to 360 degrees when performing a
scan. Ensure that the case of the Focus
hit any objects during the scan.
• CAUTION: The Focus
stable surface. Injuries may result if the Focus
equipment recommended by FARO and follow the setup instructions in this
manual or in the manual of the manufacturer of the equipment.
• If using a cart, move the setup with special care. Never move the cart by
pulling at the power cables. Pushing or pulling of the cart with too much force,
sudden stops, or an uneven surface can cause an upset of the Focus
®
FARO
3D
Figure 3-1 Focus
3D
3D
X 130 may only be used when set on a flat and
13
Chapter 3: Safety Precautions and Maintenance
Laser Scanner Focus
3D
X 130 is equipped with the
X 130 label
X 130 can rotate freely and will not
3D
X 130 overturns. Only use
3D
X 130 Manual
January 2014
3D
X 130.
3D
X 130.