Port Setup - ZyXEL Communications GS2210 Series User Manual

Chapter 8 Basic Setting
Table 12 Basic Setting > IP Setup (continued)
LABEL
Default Gateway
VID
Management IP Addresses
You can create up to 64 IP addresses, which are used to access and manage the Switch from the ports
belonging to the pre-defined VLAN(s). You must configure a VLAN first.
IP Address
IP Subnet Mask
VID
Default Gateway
Add
Cancel
Index
IP Address
IP Subnet Mask
VID
Default Gateway
Delete
Cancel

8.7 Port Setup

Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the
navigation panel to display the configuration screen.
68
DESCRIPTION
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254.
Enter the VLAN identification number associated with the Switch IP address. This is the
VLAN ID of the CPU and is used for management only. The default is "1". All ports, by
default, are fixed members of this "management VLAN" in order to manage the device
from any port. If a port is not a member of this VLAN, then users on that port cannot
access the device. To access the Switch make sure the port that you are connected to is
a member of Management VLAN.
Enter the IP address for managing the Switch by the members of the VLAN specified in
the VID field below.
Enter the IP subnet mask in dotted decimal notation.
Type the VLAN group identification number.
Enter the IP address of the default outgoing gateway in dotted decimal notation.
Click Add to insert the entry to the summary table below and save your changes to the
Switch's run-time memory. The Switch loses these changes if it is turned off or loses
power, so use the Save link on the top navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
This field displays the index number of the rule. Click an index number to edit the rule.
This field displays the IP address.
This field displays the subnet mask.
This field displays the ID number of the VLAN group.
This field displays the IP address of the default gateway.
Check the management IP addresses that you want to remove in the Delete column,
then click the Delete button.
Click Cancel to clear the selected check boxes in the Delete column.
GS2210 Series User's Guide