8.1 Overview
This chapter describes how to configure the System Info, General Setup, Switch Setup, IP
Setup, Port Setup, PoE, Interface Setup and IPv6 screens.
8.1.1 What You Can Do
• Use the System Info screen
• Use the General Setup screen
the system name and time.
• Use the Switch Setup screen
timers and assign priorities to queues.
• Use the IP Setup screen
gateway device, the default domain name server and the management VLAN ID.
• Use the Port Setup screen
• Use the PoE Status screens
that PDs are receiving from the Switch and set the priority levels for the Switch in distributing
power to PDs. This screen is available for PoE model(s) only.
• Use the Interface Setup screens
and interface ID settings.
• Use the IPv6 screens
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen as shown. You
can check the firmware version number.
GS2210 Series User's Guide
C
(Section 8.8 on page
(Section 8.3 on page
(Section 8.5 on page
(Section 8.6.1 on page
(Section 8.7 on page
(Section 8.8.1 on page
(Section 8.8 on page
(Section 8.8 on page
70) to view IPv6 status and IPv6 configuration.
H A PT ER
Basic Setting
70) to check the firmware version number.
62) to configure general settings such as
64) to choose your VLAN type, set the GARP
66) to configure the Switch IP address, default
68) to configure Switch port settings.
72) to view the current amount of power
70) to configure Switch interface type
8
60