ZyXEL Communications GS2210 Series User Manual page 85

The following table describes the labels in this screen.
Table 26 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
LABEL
Interface
IA Type
Options
Information
Refresh
Minimum
Apply
Cancel
Clear
Index
Interface
IA-NA
Rapid-Commit
DNS
Domain-List
Information
Refresh
Minimum
GS2210 Series User's Guide
DESCRIPTION
Select the IPv6 interface you want to configure.
Select IA-NA to set the Switch to get a non-temporary IP address from the DHCPv6 server
for this interface.
Optionally, you can also select Rapid-Commit to have the Switch send its DHCPv6 Solicit
message with a Rapid Commit option to obtain information from the DHCPv6 server by a
rapid two-message exchange. The Switch discards any Reply messages that do not include a
Rapid Commit option. The DHCPv6 server should also support the Rapid Commit option to
have it work well.
Select DNS to have the Switch obtain DNS server IPv6 addresses and/or select Domain-List
to have the Switch obtain a list of domain names from the DHCP server.
Specify the time interval (from 600 to 4294967295 seconds) at which the Switch exchanges
other configuration information with a DHCPv6 server again.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the nonvolatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This is the interface index number. Click on an index number to change the settings.
This is the name of the IPv6 interface you created.
This field displays whether the Switch obtains a non-temporary IP address from the DHCPv6
server.
This field displays whether the Switch obtains information from the DHCPv6 server by a rapid
two-message exchange.
This field displays whether the Switch obtains DNS server IPv6 addresses from the DHCPv6
server.
This field displays whether the Switch obtains a list of domain names from the DHCP server.
This field displays the time interval (in seconds) at which the Switch exchanges other
configuration information with a DHCPv6 server again.
Chapter 8 Basic Setting
85