ZyXEL Communications GS2210 Series User Manual page 104

Chapter 10 Static MAC Forward Setup
The following table describes the labels in this screen.
Table 35 Advanced Application > Static MAC Forwarding
LABEL
Active
Name
MAC Address
VID
Port
Add
Cancel
Clear
Index
Active
Name
MAC Address
VID
Port
Delete
Cancel
104
DESCRIPTION
Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Enter a descriptive name for identification purposes for this static MAC address forwarding
rule.
Enter the MAC address in valid MAC address format, that is, six hexadecimal character pairs.
Note: Static MAC addresses do not age out.
Enter the VLAN identification number.
Enter the port where the MAC address entered in the previous field will be automatically
forwarded.
Click Add to save your rule to the Switch's run-time memory. The Switch loses this rule if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to their last saved values.
Click Clear to begin configuring this screen afresh.
Click an index number to modify a static MAC address rule for a port.
This field displays whether this static MAC address forwarding rule is active (Yes) or not
(No). You may temporarily deactivate a rule without deleting it.
This field displays the descriptive name for identification purposes for this static MAC
address-forwarding rule.
This field displays the MAC address that will be forwarded and the VLAN identification number
to which the MAC address belongs.
This field displays the ID number of the VLAN group.
This field displays the port where the MAC address shown in the next field will be forwarded.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
GS2210 Series User's Guide