ZyXEL Communications GS2210 Series User Manual page 107

The following table describes the labels in this screen.
Table 36 Advanced Application > Static Multicast Forwarding
LABEL
Active
Name
MAC Address
VID
Port
Add
Cancel
Clear
Index
Active
Name
MAC Address
VID
Port
Delete
Cancel
GS2210 Series User's Guide
DESCRIPTION
Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Type a descriptive name (up to 32 printable ASCII characters) for this static multicast MAC
address forwarding rule. This is for identification only.
Enter a multicast MAC address which identifies the multicast group. The last binary bit of the
first octet pair in a multicast MAC address must be 1. For example, the first octet pair
00000001 is 01 and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A and
03:00:5e:00:00:27 are valid multicast MAC addresses.
You can forward frames with matching destination MAC address to port(s) within a VLAN
group. Enter the ID that identifies the VLAN group here. If you don't have a specific target
VLAN, enter 1.
Enter the port(s) where frames with destination MAC address that matched the entry above
are forwarded. You can enter multiple ports separated by (no space) comma (,) or hyphen (-
). For example, enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
Click Add to save your rule to the Switch's run-time memory. The Switch loses this rule if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to their last saved values.
Click Clear to begin configuring this screen afresh.
Click an index number to modify a static multicast MAC address rule for port(s).
This field displays whether a static multicast MAC address forwarding rule is active (Yes) or
not (No). You may temporarily deactivate a rule without deleting it.
This field displays the descriptive name for identification purposes for a static multicast MAC
address-forwarding rule.
This field displays the multicast MAC address that identifies a multicast group.
This field displays the ID number of a VLAN group to which frames containing the specified
multicast MAC address will be forwarded.
This field displays the port(s) within a identified VLAN group to which frames containing the
specified multicast MAC address will be forwarded.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
Chapter 11 Static Multicast Forward Setup
107