Lldp Configuration Basic Tlv Setting - ZyXEL Communications GS2210 Series User Manual

Chapter 31 Link Layer Discovery Protocol (LLDP)
Table 114 Advanced Application > LLDP > LLDP Configuration
LABEL
Apply
Cancel

31.6.1 LLDP Configuration Basic TLV Setting

Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP
Configuration (Click Here) > Basic TLV Setting to display the screen as shown next.
Figure 178 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting
The following table describes the labels in this screen.
Table 115 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
Port
Management
Address
Port Description
System
Capabilities
System
Description
System Name
Apply
Cancel
254
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This displays the port number on which you're configuring LLDP . Select * to configure
all ports simultaenously.
Select to enable the sending of Management Address TLVs on the port(s).
Select to enable the sending of Port Description TLVs on the port(s).
Select to enable the sending of System Capabilities TLVs on the port(s).
Select to enable the sending of System Description TLVs on the port(s).
Select to enable the sending of System Name TLVs on the port(s).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
GS2210 Series User's Guide