ZyXEL Communications GS2210 Series User Manual page 336

Chapter 44 Configure Clone
Figure 242 Management > Configure Clone
The following table describes the labels in this screen.
Table 165 Management > Configure Clone
LABEL
Source/
Destination
Port
Basic Setting
Advanced
Application
336
DESCRIPTION
Enter the source port under the Source label. This port's attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports which
are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a dash.
Example:
2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
2-6 indicates that ports 2 through 6 are the destination ports.
Select which port settings (you configured in the Basic Setting menus) should be copied to
the destination port(s).
Select which port settings (you configured in the Advanced Application menus) should be
copied to the destination ports.
GS2210 Series User's Guide