Port-Based Vlan Setup; Configure A Port-Based Vlan - ZyXEL Communications GS2210 Series User Manual

Chapter 9 VLAN
Table 33 Advanced Application > VLAN > VLAN Port Setting > Protocol Based VLAN Setup
LABEL
VID
Priority
Delete
Cancel

9.7 Port-based VLAN Setup

Port-based VLANs are VLANs where the packet forwarding decision is based on the destination MAC
address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port. Therefore, if you wish
to allow two subscriber ports to talk to each other, for example, between conference rooms in a
hotel, you must define the egress (an egress port is an outgoing port, that is, a port through which
a data packet leaves) for both ports.
Port-based VLANs are specific only to the Switch on which they were created.
Note: When you activate port-based VLAN, the Switch uses a default VLAN ID of 1. You
cannot change it.
Note: In screens (such as IP Setup and Filtering) that require a VID, you must enter 1
as the VID.
The port-based VLAN setup screen is shown next. The CPU management port forms a VLAN with all
Ethernet ports.

9.7.1 Configure a Port-based VLAN

Select Port Based as the VLAN Type in the Basic Setting > Switch Setup screen and then click
Advanced Application > VLAN from the navigation panel to display the next screen.
98
DESCRIPTION
This field shows the VLAN ID of the port.
This field shows the priority which is assigned to frames belonging to this protocol based
VLAN.
Click this to delete the protocol based VLANs which you marked for deletion.
Click Cancel to begin configuring this screen afresh.
GS2210 Series User's Guide