Led Mode (Only Available For Gs2210-48Hp); Rear Panel; Console Port; Power Connector - ZyXEL Communications GS2210 Series User Manual

Chapter 3 Hardware Panels

3.1.3 LED Mode (only available for GS2210-48HP)

After you push this button (see
LEDs to ensure proper functioning of the Switch and as an aid in troubleshooting (see
on page 31).

3.2 Rear Panel

The following figures show the rear panels of the Switch.
Figure 16 Rear Panel: GS2210-24
Figure 17 Rear Panel: GS2210-24HP
Figure 18 Rear Panel: GS2210-48
Figure 19 Rear Panel: GS2210-48HP

3.2.1 Console Port

For local management, you can use a computer with terminal emulation software configured to the
following parameters:
• VT100
• Terminal emulation
• 9600 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
Connect the male 9-pin end of the console cable to the console port of the Switch. Connect the
female end to a serial port (COM1, COM2 or other COM port) of your computer.

3.2.2 Power Connector

Note: Make sure you are using the correct power source as shown on the panel.
30
Section Figure 10 on page 27) to active PoE on the Switch, view the
GS2210 Series User's Guide
Section 3.3