ZyXEL Communications GS2210 Series User Manual page 278

Chapter 34 DHCP
Figure 197 IP Application > DHCP > DHCPv4 > VLAN
The following table describes the labels in this screen.
Table 132 IP Application > DHCP > DHCPv4 > VLAN
LABEL
VID
Remote DHCP
Server 1 .. 3
Option 82
Profile
Add
Cancel
Clear
VID
Type
DHCP Status
278
DESCRIPTION
Enter the ID number of the VLAN to which these DHCP settings apply.
Enter the IP address of a DHCP server in dotted decimal notation.
Select a pre-defined DHCP option 82 profile that the Switch applies to all ports in this VLAN.
The Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the
profile to DHCP requests that it relays to a DHCP server.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This field displays the ID number of the VLAN group to which this DHCP settings apply.
This field displays Relay for the DHCP mode.
For DHCP server configuration, this field displays the starting IP address and the size of the
IP address pool.
For DHCP relay configuration, this field displays the first remote DHCP server IP address.
GS2210 Series User's Guide