Table of Contents
Advertisement
M o u n t i n g h o l e
Cut a round hole with a diameter
of 182 mm (7.2 in) in the panel in
which the Alien 05 is to be
installed. A cardboard ceiling
cutout template is supplied.
Note that it may be advisable to
perform this step for all the Alien
05s that are being installed, and
t o t h e n l a y t h e p o w e r a n d
network cables between each
mounting hole, before inserting the luminaires. See the following sections.
C o n n e c t i o n a n d m o u n t i n g
To install the Alien 05 Recessed:
1 Connect the power leads from the 12 V AC halogen lamp transformer.
Anchor these securely by tightening the screws. Note that the cable length
between the transformer and the Alien 05 must not be more than 45 cm
(17.7 inches).
2 Connect a CAT5 network cable that is directly or indirectly connected to the
05 Driver unit and, if the lamp is to be daisy-chained to a subsequent lamp,
connect a CAT5 network cable for the link to the next fixture. Note that it
does not matter which network socket is used.
Power
cables from
transformer
(12 V AC)
Installing an Alien 05 Recessed
182 mm
CAT5
network
cables
15
Advertisement
Table of Contents
