Installing An Alien 05 Eyeball; Fixture Location - Martin Alien 05 User Manual

Installing an Alien
05 Eyeball
This section describes in general terms how to mount the fixture and
connect it to data and AC power. These procedures shall be performed by
qualified professionals.
We recommend that you perform the installation steps in the following order:
1 Install the 05 Driver and 05 Repeaters. See the 05 Driver user manual and
the 05 Repeater user manual.
2 Identify locations for the your Alien 05 Eyeballs using the guidelines below.
3 Perform the pre-requisites described in "Prerequisites" on page 14.
4 Connect the recessed fixture housing to the network (see "Install the
network" on page 18).
5 Install the fixture using the procedure in "Connecting and mounting an Alien
05 Eyeball" on page 19
F i x t u r e l o c a t i o n
The Alien 05 Eyeball can be used as either a ceiling fixture, or be positioned
in a wall as an up-light, down-light or sidelight.
The Alien 05 Eyeball must be installed in a Cooper Lighting, Halo brand,
recessed low-volt non-IC fixture housing (item # H7LVT). For more
i n f o r m a t i o n
(http://www.cooperlighting.com/brands/halo/index.asp).
Do not locate the Alien 05 Eyeball in an unventilated space. Install the
fixture in a location where it is:
• At least 0.5 meters (20 inches) away from the surface to be illuminated.
• Away from accidental public contact, as the surface of the sphere gets hot -
up to 90 ° C (194° F).
• Not more than 40 cable metres away from the 05 Driver/05 Repeater.
r e f e r t o t h e

Installing an Alien 05 Eyeball

C o o p e r L i g h t i n g
4
w e b s i t e
17