Installing An Alien 05 Recessed; Fixture Location - Martin Alien 05 User Manual

Installing an Alien
05 Recessed
This section describes in general terms how to mount the fixture and
connect it to data and AC power. These procedures shall be performed by
qualified professionals.
We recommend that you perform the installation steps in the following order:
1 Install the 05 Driver and 05 Repeaters. See the 05 Driver user manual and
the 05 Repeater user manual.
2 Identify locations for the Alien 05s using the guidelines below.
3 Identify and acquire the pre-requisites described in "Prerequisites" on page
14.
4 Cut mounting holes (see page 15).
5 Lay the network cables between the 05 Driver/05 Repeaters and the Alien
05 mounting holes. See page 7.
6 Install the transformers close to the Alien 05 mounting holes and connect
them to the 05 Driver or power supply. See page 9.
7 Connect the Alien 05 to the network and transformer cables and install it in
the mounting hole. See page 15.
F i x t u r e l o c a t i o n
The Alien 05 Recessed can be used as either a ceiling fixture, or be
positioned in a wall as an up-light, down-light or sidelight.
Do not locate the Alien 05 recessed in an unventilated space. Install the
fixture in a location where it is:
• At least 0.5 meters (20 inches) away from the surface to be illuminated.
• Away from accidental public contact, as the surface of the sphere gets hot -
up to 90 ° C (194° F).
• Not more than 45 cm (17.7 inches) cable length away from the transformer.

Installing an Alien 05 Recessed

3
13